YANMAR small engine replacment engine control panel, wiring loom and engine harness
If you have a small YANMAR marine diesel engine and need to start again with the wiring this is the kit for you.
What you have is:
Control Panel:
The control panel 195mm by 85mm is fed by a heavy duty 50amp cable through a heavy duty 50amp fuse. This runs to a isolation switch. Allowing you to isolate the boat and turn the panel off at the same time.
There is a heavy duty pushbutton engine start switch.
There are warning lights for engine charge, low oil pressure and high water temp.
Wiring loom:
The panel is hard wired to a 3 meter wiring loom ending in a 11 way multi plug
Engine wiring harness:
There is a engine wiring harness running from a 11 way multiplug to the starter, alternator and warning sensors.
The panel and all its parts are IP67 waterproof and it comes with a wiring diagram.