This is our 5Amp waterproof key switch.
The wiring for this switch is Red feed in Black switched out.
Very simple OFF - ON function.
25 mm hole, snap fit into up to 7 mm thick bulkhead. 60 mm space required to the rear.
This is our 3 position OFF-ON-START ignition switich.
22 mm hole and 10 mm bulkhead with a screw bezel fixing. 60 mm space to rear.
The wiring is:
1 feed in 10Amp max
2 ignition on
3 engine start - spring loaded
This is our 10Amp three position OFF-ON-START waterproof ignition switch.
This one is ideal for all you narrowboat owners. The key has a cover built in so the lock is protected on those long rainy days.
The wiring is through 3 screwed connectors:
1 Feed in 10A max
2 ignition on
3 Start - spring loaded
25 mm hole. 10 mm bulkhead. 60 mm space to rear. screw bezel fixing'
This 15Amp ignition switch has a rubber cover to keep the switch waterproof while it is not being used. It also has a rubber key grip to keep the water out while it is being used!
22 mm hole and a 10mm bulkhead. fixing through a screw bezel which is metal and very strong. 60mm space to rear + wiring.
Wiring is through 6.5mm female spade connectors:
two connectors for the feed 15Amp max marked BATT
two connectors for the ignition on marked IGN
one connector for the start marked ST
two connectors for the AUX position marked Acc
This is our most heavy duty ignition switch at 20Amps. A 4 position switch AUX-OFF-ON-START key out only at off and spring loaded start.
18mm hole and 10mm bulkhead with a set washer on the thread. Fixing through bezel which is metal and very strong.
Wiring is through 5mm poles fixed by a nut:
Feed 20A max is through the pole marked BAT
On is through the pole marked IGN
AUX is through the pole marked ACC
Start is through the top exposed pole.
90mm space to rear